Calculate the SCFM.
Operating Instructions for Flameless Electric Air Heaters
Performance Characteristics - Style 001
Nozzled Air Heaters
Open Air Heaters
Performance Characteristics - Style 003
Mount heater in desired position. Care should be taken not to restrict exit end of heater. Mechanical shock and vibration should be minimized. Those heaters with quartz envelopes () should be handled with a protective layer of cloth or paper to prevent contamination from finger prints. If quartz is contaminated, it should be cleaned with soap and water or mild solvent prior to operation of heater.
Connect a clean filtered and regulated air source to the inlet air connection of the heater. This air must be free of oils and other forms of contamination to prevent drastic reduction of heater life. A means of regulation is required so that the air flow rate can be adjusted and controlled which will allow maximum heater performance flexibility. A blower capable of operating at 1-2 PSI can be used to supply the 13” housing (). A compressed air source is required for the other heater types because of the higher pressures involved.
Electric Power Connections
#Electric connections are made through ¼ x .032 male disconnects provided on Style 001 heaters or through the lead wires provided on
View phase angle controls and learn more about the specifications for our newest control consoles.
Consult performance curves before operation of heater. Air temperature and ultimately the heater life depend on the heater type, the air flow rate, and the applied voltage. Do not operate beyond the recommended limits. Maximum heater life will occur when the filament temperature does not exceed 1950° F.
Turn on air source and adjust to desired flow rate before applying voltage to heater. Air flow should not be stopped until after power has been turned off and heater has cooled. Pressure switches are available, which can be used to automatically turn off power if air flow is too low or stopped.
Turn on power source and increase voltage until desired temperature is reached. When automatic controls are used, set voltage limiting adjustment so that the maximum voltage does not exceed 100% of the normal steady state value required to maintain the desired conditions. Too high a setting will cause the heater to overshoot, cycle excessively and reduce its life. Do Not use zero cross systems.
When a shield or flare is used with theheaters the heater becomes more efficient and therefore the required power will be 10-20% less than normal.