Terminations

Tubular Heater Products

Tubular Electric Heaters - Terminations

Figure B1

Stainless Steel threaded stud terminal with ceramic insulator.
Standard terminal configuration*

Standard Thread

.250 Dia #6-32
.312 Dia #6-32
.375 Dia #8-32
.430 Dia #10-32
Figure B1 Figure B1
Figure B1

Figure B2

Flag terminal - projection welded
Available in both #8-32 and #10-32.

Figure B2 Figure B2
Figure B2

Figure B3

Flag terminal - side projection welded
Available in both #8-32 and #10-32.

Figure B3 Figure B3
Figure B3

Figure B4

Quick-connect - projection welded

Figure B4 Figure B4
Figure B4

Figure B5

Quick-connect - projection welded

Figure B5 Figure B5
Figure B5

Figure B6

Lead wire. Please specify length.
(12” standard w/ 2” standard sleeve)

Figure B6 Figure B6
Figure B6

*Stainless Steel terminals

Other thread sizes and thread lengths are available to accomodate your requirements.

*Hermetic Seals available upon request

INDUSTRY-NET-PREFERRED-SUPPLIER-LOGO
  • Calculator
  • Standard Flow Rate (SCFM) Calculator

    Calculate the SCFM.

    Power Flowrate Calculator

    Calculate the electrical power, flow rate or temperature requirement.

    Temperature Conversion

    Fill in one value to calculate the other.

    Ohms Law Calculator

    Fill in two values to find the other two.

    Pressure Conversion

    Fill in one value to calculate the other.

    Three Phase Unit Calculator

    Fill in two values to find the 3rd.

    Single Phase Unit Calculator

    Fill in two values to find the 3rd.

    Parallel Resistance Calculator

    Calculate the total resistance in ohms of resistors that are in parallel by entering the value of each below.

    Series Resistance Calculator

    Calculate the resistance in ohms of resistors connected in series by entering the value of each.

    Copyright © 2024 Convectronics. All Rights Reserved.