Temperature Sensors

Thermocouple Junction Types 

In general the Grounded Junction offers the best compromise of performance and reliability. It is usually the best choice for general purpose measurements. If your leadwire will be shielded and attached to the sheath, select an Ungrounded Junction.

The Ungrounded Junction is also used to avoid ground loops between instruments, power supplies and the sensor. If you are unsure of the Junction Type you require, contact our staff of engineers who will be happy to assist you.

How do I select a Thermocouple Junction Type? 

Grounded Junction Grounded Junction
Grounded Junction

The sheath and conductors are welded together forming a completely sealed integral junction. Recommended in the presence of liquids, moisture, gas or high pressure. The wire is protected from corrosive or erosive conditions. Response time with this style approaches that of the exposed junction.

Ungrounded Junction Ungrounded Junction
Ungrounded Junction

On this type, the thermocouple junction is fully insulated from the welded sheath end. The ungrounded junction is excellent for applications where stray EMF’s would affect the reading and for frequent or rapid temperature cycling. Response time is longer than for the grounded junction.

Exposed Junction Exposed Junction
Exposed Junction

Thermocouple wires are welded and insulation is sealed against liquid or gas penetration. This junction style provides the fastest possible response time but leaves the thermocouple wires unprotected against corrosive or mechanical damage.

INDUSTRY-NET-PREFERRED-SUPPLIER-LOGO
  • Calculator
  • Standard Flow Rate (SCFM) Calculator

    Calculate the SCFM.

    Power Flowrate Calculator

    Calculate the electrical power, flow rate or temperature requirement.

    Temperature Conversion

    Fill in one value to calculate the other.

    Ohms Law Calculator

    Fill in two values to find the other two.

    Pressure Conversion

    Fill in one value to calculate the other.

    Three Phase Unit Calculator

    Fill in two values to find the 3rd.

    Single Phase Unit Calculator

    Fill in two values to find the 3rd.

    Parallel Resistance Calculator

    Calculate the total resistance in ohms of resistors that are in parallel by entering the value of each below.

    Series Resistance Calculator

    Calculate the resistance in ohms of resistors connected in series by entering the value of each.

    Copyright © 2024 Convectronics. All Rights Reserved.