Tubular Heater Products

Tubular Electric Heaters - Mounting Methods

Bushings

A threaded bushing is brazed or welded to the sheath to provide quick, rigid, liquid or air-tight mounting through tank walls, oven walls, etc.

• Available in Brass or Stainless Steel
• All bushings furnished with plated washer,
  compressed non-asbestos gasket and jam nut
• Hex head bushings are standard
• Specify location from end of sheath

Diameter Thread Size Hex Dimension A
.250” 1/2-20 3/4 1"
.312” 1/2-20 3/4 1"
.375” 5/8-1/8 1 1"
.430” 3/4-16 1 1"
Gasket / Washer DiagramGasket / Washer Diagram

Locator Rings

Locator rings are permanently attached to the heater sheath and are used to limit the movement of the heater while allowing for expansion and contraction of the heater sheath. When ordering, please specify the location from the end of the sheath.

Tubular Electric Heaters - Mounting MethodsTubular Electric Heaters - Mounting Methods

Mounting Brackets

The 16 gauge stainless steel mounting bracket is an economical way to mount the heater in non-pressurized, non-liquid applications. Unless otherwise specified the brackets will be located 1/2” (13 mm) from the edge of the heater sheath.

Tubular Electric Heaters - Mounting MethodsTubular Electric Heaters - Mounting Methods

* All letter designated dimensions must be supplied by the customer.

INDUSTRY-NET-PREFERRED-SUPPLIER-LOGOINDUSTRY-NET-PREFERRED-SUPPLIER-LOGO
INDUSTRY-NET-PREFERRED-SUPPLIER-LOGOINDUSTRY-NET-PREFERRED-SUPPLIER-LOGO
  • Calculator
  • Standard Flow Rate (SCFM) Calculator

    Calculate the SCFM.

    Power Flowrate Calculator

    Calculate the electrical power, flow rate or temperature requirement.

    Temperature Conversion

    Fill in one value to calculate the other.

    Ohms Law Calculator

    Fill in two values to find the other two.

    Pressure Conversion

    Fill in one value to calculate the other.

    Three Phase Unit Calculator

    Fill in two values to find the 3rd.

    Single Phase Unit Calculator

    Fill in two values to find the 3rd.

    Parallel Resistance Calculator

    Calculate the total resistance in ohms of resistors that are in parallel by entering the value of each below.

    Series Resistance Calculator

    Calculate the resistance in ohms of resistors connected in series by entering the value of each.

    Copyright © 2022 Convectronics. All Rights Reserved.