Flameless Electric Air Heaters

Power Control Module


Part # 006-10062

The Power Control Module offers infinitely variable phase control when used with resistive loads up to 25 amps. The solid state circuitry provides modified transient suppression, exceptional stability and life. An external potentiometer/switch (dial plate and knob included) is used to control output voltage. A trimming potentiometer is mounted on top of the module to adjust turn on voltage level. This device should be installed in a circuit fused at 120% rated load or 30 amps maximum.

Input voltage:   110-277 volts, single phase, 60 Hz.
Output voltage:   Adjustable from 17% to 99% of applied voltage
Current rating:   25 amps maximum (see ambient temperature vs. current curve)
Power consumption:   (maximum): 50 watts
Maximum temp:   75°C Measured at center of base plate

Part Number # 006-10139

Heat Sink
Recommended for load
currents exceeding 15 amps
(see ambient temperature
vs. current curves shown above)

INDUSTRY-NET-PREFERRED-SUPPLIER-LOGOINDUSTRY-NET-PREFERRED-SUPPLIER-LOGO
INDUSTRY-NET-PREFERRED-SUPPLIER-LOGOINDUSTRY-NET-PREFERRED-SUPPLIER-LOGO
  • Calculator
  • Standard Flow Rate (SCFM) Calculator

    Calculate the SCFM.

    Power Flowrate Calculator

    Calculate the electrical power, flow rate or temperature requirement.

    Temperature Conversion

    Fill in one value to calculate the other.

    Ohms Law Calculator

    Fill in two values to find the other two.

    Pressure Conversion

    Fill in one value to calculate the other.

    Three Phase Unit Calculator

    Fill in two values to find the 3rd.

    Single Phase Unit Calculator

    Fill in two values to find the 3rd.

    Parallel Resistance Calculator

    Calculate the total resistance in ohms of resistors that are in parallel by entering the value of each below.

    Series Resistance Calculator

    Calculate the resistance in ohms of resistors connected in series by entering the value of each.

    Copyright © 2022 Convectronics. All Rights Reserved.